Dirty block paved driveway
Pressure washed driveway

Driveway and Patio Cleaning

We use a variety of cleaning methods; cold water pressure wash, hot water or steam pressure wash and the use of chemicals. The different methods allow us to tailor our service to your specific needs and budget.

We offer services of cleaning only, cleaning, oil and stain removal and re-sanding, sealing, painting and small repairs. At times the use of products can significantly improve the look of your driveway even after pressure washing, we would discuss this with you when giving a quote. 

The types of surfaces we clean;

  • Block paving

  • Natural stone

  • Tarmac

  • Pattern imprinted concrete

  • Resin bound or bonded driveways

  • Cobblestone driveways

  • Decking

The process is different depending on the type of surface, the general cleaning process is as follows;

  • Sweeping and clearing the area to be cleaned

  • The use of high pressure jets/rotary surface cleaner (depending on the surface)

  • Low pressure rinse

  • Inspection of the area to ensure everything is 100% clean

  • If required any further cleaning products would be applied now

  • Clean up of surrounding areas

  • If required, we would return after a couple of dry days to re-sand the joints

For sealing the process is similar to above;

  • Sweeping and clearing the area to be cleaned

  • The use of high pressure jets/rotary surface cleaner (depending on the surface)

  • Low pressure rinse

  • Inspection of the area to ensure everything is 100% clean

  • If required any further cleaning products would be applied now

  • Clean up of surrounding areas

  • A return visit after 3/4 days of dry weather to re-sand the joints and apply sealant

Before%20and%20after%20a%20satin%20seale

This patio was pressure washed and then sealed with a satin finish. This brings out the colour in the stone and protects it for longer from dirt, grime and weeds.

FAQ's

Does it make much mess?

In short, yes. Pressure washing uses high pressured water to remove the dirt. This dirt will spray up onto surrounding area's. We make every effort to minimise this from happening and will cover any surfaces that require it. Once we have completed the clean, we will rinse off any area/surface that has been affected. 

Will my patio/driveway look like new?

With every clean we undertake, we are confident we can bring that surface to the best standard possible. A brand new look isn't always achievable but it will look the best it can. Many factors influence this, including but not limited to: the age, the quality, location due to environmental factors and any previous treatments it may have had.

 

How long does it take?

Again, many factors influence the time required to complete a clean. Size, condition, drainage and water flow all affect the time frame but as a general rule, we say around an 45 mins  for each car that could fit on the area.

How much does it cost?

This is the question that is asked the most and also the most difficult to answer. For standard pressure washing, the prices start at around £2 per square metre, this depends on the type of surface, general condition and drainage. The re-sanding of any joints is included in the price.

Whatever your needs J.K. Aidan will complete the job to the highest possible standard, leaving the customer with 100% satisfaction.

*Access to mains water and electricity required.

Click here for terms and conditions.

YoungmanLogoblack2.jpg
Swiss-Seal.png
flexi.jpg
Get In Touch For A Quote Today.

©2019 by J.K.Aidan cleaning services LTD

J.K. Aidan Cleaning Services ltd